From 293b9f05a15be7d4537f936acbfa7973b06fd068 Mon Sep 17 00:00:00 2001 From: Chris Murphy Date: Sep 04 2020 22:24:49 +0000 Subject: refreshing local standard disks UI for adding new local storage, and rescanning, has been relocated. --- diff --git a/modules/install-guide/pages/_partials/install/StorageSpoke.adoc b/modules/install-guide/pages/_partials/install/StorageSpoke.adoc index 1a8ef31..8037203 100644 --- a/modules/install-guide/pages/_partials/install/StorageSpoke.adoc +++ b/modules/install-guide/pages/_partials/install/StorageSpoke.adoc @@ -20,7 +20,7 @@ image::anaconda/StorageSpoke.png[The Installation Destination screen. There are In the top part of the screen, all locally available storage devices (SATA, IDE and SCSI hard drives, USB flash drives, etc.) are displayed in the `Local Standard Disks` section. Local disks are detected when the installer starts - any storage devices connected after the installation has started will not be shown. -If you need to configure additional local storage devices, select `I will configure partitioning` and press `Done` to move to xref:Installing_Using_Anaconda.adoc#sect-installation-gui-manual-partitioning[Manual Partitioning]. Then, connect any new hard drives you want to make available during the installation, and press the button marked by a circular arrow in the set of controls below the list of mount points on the left side of the screen. In the dialog window that opens, press `Rescan Disks` and wait until the scanning process completes. Then, press `OK` to return to xref:install/Installing_Using_Anaconda.adoc#sect-installation-gui-storage-partitioning[Installation Destination]; all detected disks including any new ones will be displayed in the `Local Standard Disks` section. +If you need to configure additional local storage devices, select `Refresh` on the lower-right corner. Follow the instructions in the dialog that opens. All detected disks, including any new ones, will be displayed in the `Local Standard Disks` section. The `Specialized & Network Disks` section below shows advanced network storage (such as iSCSI and FCoE disks) currently configured. When you first open this screen, no such devices will be displayed because they can not be automatically detected; to search for network storage devices, press `Add a disk` button and proceed with xref:Installing_Using_Anaconda.adoc#sect-installation-gui-installation-destination[Installation Destination - Specialized & Network Disks]. Any network storage you configure will then show up in the `Specialized & Network Disks` the same way local disks are shown above.